dscDIOSetBit

BYTE dscDIOSetBit(DSCB board, BYTE port, BYTE bit);

Sets the specified digital output bit of the specified port to 1 while leaving the other bits in their present states.

NOTE: dscDIOSetConfig must be called to configure the direction prior to using this function.

Some boards (Diamond-MM, Diamond-MM-AT, Diamond-MM-16-AT, Opal-MM, Pearl-MM, Quartz-MM) do not have readback capability on the digital output ports. Therefore the driver maintains its own history of the last-written values to these ports, so that it can correctly modify only the bit of interest. In order for this function to work correctly, the driver must always know the present state of the digital output bits. This can only happen if you always use the driver for digital output operations. If you mix driver calls with direct I/O to the digital output ports, the bit operations can fail, since the driver will have no record of what your program has done directly.

Input Parameters

Name	Description
DSCB	The handle of the board to operate on Port Selected
Port	Selected output port
Bit	Bit location (0-7) to write on the selected input port

Return Value

Error code or 0.