Onyx-MM-DIO
This product is supported for DSCUD 8.0 and above.
Board Initialization
To use the Onyx-MM-DIO board in an appllication using the UD, the dscInitBoard function should use the board macro DSC_OMMDIO. This is shown in the example below.
Digital I/O
Ports: | 6 8-bit bidirectional ports (2 82C55 chips) Digital I/O ports on Onyx-MM-DIO require direction to be set with dscDIOSetConfig() before use. One configuration byte is required for each 82C55 chip. All DIO lines power-up in input mode and have readback capability. All DIO lines have 10K Ohm pull-up resistors. Interrupts Not supported on this board. |
Onyx-MM-DIO Universal Driver Functions
Last updated