Digital I/O Functions

BYTE SATURNDIOConfig(BoardInfo* bi, int Port, int Config);

This function sets the digital I/O port direction for the selected port.

Input parameters:

port	int	0-2 for port A, B, C
config	int	8-bit configuration values for selected port

This function operates as follows:

Set page = 2

Write configuration byte Config to base address + 8 + Port (8, 9 or 10)

Set page = 0

Exit

BYTE SATURNDIOConfigAll(BoardInfo* bi, int* Config);

This function sets the digital I/O port directions for all ports at once.

Input parameters:

Config

int *

pointer to 3 8-bit configuration values for ports A, B, C

This function operates as follows:

Set page = 2

Write 4 configuration values in Config array to base address + 8, 9 and 10

Set page = 0

Exit

BYTE SATURNDIOOutputByte(BoardInfo* bi, int Port, byte Data);

This function outputs the specified data to the specified port. The data is 8 bits for ports A , B and 6 bits for port C.

Input parameters:

Port	int	0=A, 1=B, 2=C
Data	int	6 or 8 bit value to write to the port; for port C only the lower 6 bits are used, the upper 2 are ignored by the FPGA

This function operates as follows:

Set page = 2

Write data to register 8 + port no.

Set page = 0

Exit

BYTE SATURNDIOInputByte(BoardInfo* bi, int Port, byte* Data);

This function reads in the data from the specified port and returns it in the location specified by the pointer to data.

Input parameters:

Port	int	0 = A, 1 = B, 2 = C
Data	int *	pointer to receive the data read from the port

This function operates as follows:

Set page = 2

Read the register specified by Port

Store the value in the location specified by Data

Exit

BYTE SATURNDIOOutputBit(BoardInfo* bi, int Port, int Bit, int Value);

This function outputs a single bit to an output port. The other bits remain at their current values.

Input parameters:

Port	int	Port to write bit to: 0 = A, 1 = B, 2 = C
Bit	int	0-7 indicates the bit position in the port (for port C the value should be 0-5)
Value	int	0 or 1

This function operates as follows:

Set page = 2

Read the register specified by Port number (since port is in output mode this reads the output register value)

If Value = 0 then mask off selected bit and rewrite data

If Value = 1 then or in selected bit and rewrite data

Set page = 0

Exit

BYTE SATURNDIOInputBit(BoardInfo* bi, int Port, int Bit, int* Value);

This function reads in the specified bit from the specified port and returns it in the location specified by the pointer to data.

Input parameters:

Port	int	0 = A, 1 = B, 2 = C
Bit	int	0-7 for ports A and B, 0-5 for port C
Value	int *	pointer to receive the bit data; return data is always 0 or 1

This function operates as follows:

Set page = 2

Read the register specified by Port number

Mask off the selected bit and right shift into bit 0; return data is always 0 or 1

Store the value in the location specified by Value

Set page = 0

Exit