dscADSetSettings

BYTE dscADSetSettings(DSCB board, DSCADSETTINGS* adsettings);

Sets the A/D configuration for future A/D conversions. A delay of approximately 10 microseconds occurs during this function call in order to allow the analog circuit on the board to settle on the new settings. On -AT (auto-calibrating) boards, if adsettings->load_cal is TRUE, then load the A/D calibration settings from the EEPROM for the current A/D range. This results in slightly more accurate A/D conversions but causes an additional, longer delay of approximately 10 milliseconds.

Input Parameters

Name	Description
DSCB	The handle of the board to operate on
DSCADSETTINGS	The A/D scan settings to be used

Return Value
Error code or 0.