9. SYSTEM ASSEMBLY

This page describes the system assembly instructions for Floyd SC daughter board

9.1 General Description

1. Assemble Floyd SC base board. Refer Floyd SC user manual.

2. Assemble Floyd SC base board over Floyd SC daughter card.

9.2 Required Parts

9.3 Assembly Instruction

1. Place the Floyd SC daughter board with PCB topside facing down. Use the 4 M3 20mm M/F standoffs(item 5 in section 10.2) to raise the Floyd SC daughter board off the table top.

2. Screw the M3 10mm F/F spacers(item 3 in section 10.2) on to the M3 M/F standoffs.

3. Place the Floyd SC baseboard topside facing up on top of the M3 F/F standoffs.

4. Screw the M3 5mm screws from the top into the M3 F/F standoffs.

5. Connect the cable DSC# 6971400 from Floyd SC(J9) to Floyd SC Daughter board(J5).