11.1. Mounting Module on carrier board

This section provides instructions on mounting the EPS-10GX4 switch on the carrier board.

1. Connect the serial cable on the carrier board to a PC’s serial port.

2. Open the HyperTerminal application with a baud rate set to 115200 bps.

Based on the number of active ports to be used:

3. Connect the Ethernet cables from the PC’s Ethernet port/Ethernet switch to any of the Ethernet connectors on the carrier board.

4. Connect a LAN cable between the PC to any one of the desired ports on the cable(s) connected to the EPS-10GX4 switch specified in step 3.

5. Turn on the power supply and view the messages on the Hyper Terminal.

6. The default User Id is admin. No password is required.

7. The default IP Address of switch is 192.168.1.60. To access the Web Interface, open up the browser, type in this address and hit Enter. Type in the username (admin) when prompted.