TABLE OF CONTENTS

This page shows the Table of Contents in the JTEBOX-FLOYD system manual.

1. IMPORTANT SAFE HANDLING INFO

2. INTRODUCTION & PRODUCT CONFIGURATIONS

   2.1 INTRODUCTION

   2.2 PRODUCT CONFIGURATIONS

3. FUNCTIONAL OVERVIEW

   3.1 POWER SUPPLY SPECIFICATIONS

   3.2 USB PORTS

   3.3 HDMI PORTS

   3.4 ETHERNET PORTS

   3.4.1 POWER OVER ETHERNET

   3.5 SERIAL PORTS OVERVIEW

   3.6 DIO OVERVIEW

   3.7 EXPANSION CONNECTORS

   3.7.1 EXP 1

   3.7.2 EXP 2

4. BLOCK DIAGRAM

5. MECHANICAL DRAWING

   5.1 3D STEP MODEL

   5.2 2D DRAWING

6. CONNECTORS LEDs AND JUMPER LOCATIONS

   6.1 FLOYD CARRIER BOARD CALLOUTS - TOP VIEW

   6.2 FLOYD CARRRIER BOARD CALLOUTS - BOT VIEW

   6.3 FLOYD CARRIER BAORD CALLOUTS - FRONT VIEW

7. JUMPER CONFIGURATION

   7.1 JP1: DIO PULL UP/DOWN ENABLE/DISABLE

   7.2 JP2:PROTOCOL MODE SEL & TERMINATION ENABLE

   7.3 JP3: USB2.0 - 1 MODE SEL

8. CONNECTOR PINOUTS

   8.1 INPUT POWER

   8.2 SERIAL PORTS

   8.2.1 SERIAL PORT 1 (SER 1)

   8.2.2 EXP 1 SERIAL PORT 2 (SER 2)

   8.3 USB PORTS

   8.3.1 USB2.0 PORTS

   8.3.2 USB3.0 PORT

   8.4 HDMI

   8.5 ETHERNET

   8.6 EXP 2: DIGITAL I/Os

   8.7 EXP 1: OPTIONAL CAN

   8.8 EXP 2 OPTIONAL PoE

   8.9 J19: M.2 PCIe SSD

   8.10 J17: MICRO SD

   8.11 J15: RTC

   8.12 J16: UTILITY

   8.13 J20: FAN

   8.14 J12,J13,J14: CSI CAMERA

9. I/O CONNECTOR LIST

10. EXPANSION SOCKETS

11. POWER OVER ETHERNET

12. GETTING STARTED

13. SYSTEM ASSEMBLY

    13.1 INSTALLING THE JETSON MODULE ON FLOYD

    13.2 INSTALLING FLOYD INSIDE THE JETBOX

14. REPROGRAMMING THE EMBEDDED LINUX IMAGE

    14.1 HARDWARE SET UP

    14.2 SOFTWARE SET UP

    14.2.1 FLASHING THE JETSON NANO MODULE

    14.2.2 FLASHING THE JETSON XAVIER NX MODULE

15. DIGITAL I/O

16. SERIAL PORTS

17. I/O EXPANSION

18. SPECIFICATIONS

19. LIMITED WARRANTY POLICY