14.2 Programming the D/A wave form generator

This section details how to program the D/A waveform generator through direct I/O without using the driver software. Please note that the D/A waveform generator is an enhanced feature and users must enabled enhanced features to access the feature. Details of the D/A waveform register map can be found at page 31. There are 6 steps to programming the D/A waveform generator

1. Enable enhanced features

2. Reset D/A waveform pointer

3. Latch D/A value

4. Store D/A values into buffer

5. Setup D/A wave form settings

6. Start D/A waveform generator